A RAID 1 set reports one failed member, but the system still boots normally. What should the technician do to restore redundancy?

AReformat the remaining good drive

BDisable RAID mode in firmware

CReplace the failed drive and let the array rebuild

DConvert the disk to removable media

More Hardware and Network Troubleshooting Questions

14 questions

Full CompTIA A+ Core 1 V15 Practice Test

All topics covered

All CompTIA A+ Core 1 V15 Questions

Browse by topic

Related Questions

A desktop powers on briefly, then shuts off, and the BIOS hardware monitor shows CPU temperature ris...

hard

A PC emits memory-related POST beeps and fails to boot right after a RAM upgrade. What should the te...

medium

A desktop will not power on at all and no fans spin. After confirming the wall outlet works, what sh...

medium

A hard drive makes repeated clicking noises and SMART reports warnings. What is the best recommendat...

medium

A projector image appears wider at the top than the bottom after the projector is angled upward. Whi...

medium

View all Hardware and Network Troubleshooting questions

Educational Content — CertQnA practice questions are written against official exam objectives, covering the same domains tested on the real exam. All content is original and independent — not actual exam questions, not affiliated with any certification vendor. Learn more about our content policy

Discussion

Be the first to share your understanding of this concept

⚠️ Discussion is for concept clarification only. Do not share or request actual exam questions or answers.